User Manual

4
Setup the Connection between the Receiver and the Mouse,
Keyboard.
1. Plug the RF receiver into the USB port of your computer.
2. Insert the batteries into the mouse and keyboard, then follow the steps
below.
3. If the mouse or the keyboard is not working, please put them into
pair mode.
4. Pairing: Re-plug the receiver into the USB port of your computer, then
press connect button of the moue and keyboard. If the mouse or
keyboard does not work after 10 seconds, pair them again. (The
receiver has auto pairing function).
5.The LED indicators on receiver flashes when the mouse is moving or
when the keyboard is in use.
6. When the battery of the keyboard is low, the Low Power indicator
would blink.
Scrolling Wheel &
LED Indicator
*Mouse Indicator
Red LED is on for 10 sec.
Power ON
Red LED Blinking
Pairing (LED OFF when paired or
failed after 10 sec.)