User's Manual

AcroLAN Access Point User’s Guide

Version 2000.12.10

Page 28 of 28

2.3 Verifying the Operation of the Acrowave Access Point

The AP runs a series of self-tests on power-up and reports status using its LEDs.

When power-up begins, the following occurs:

The firmware begins running diagnostics, initializes minimal hardware.

After the firmware completes its diagnostics and hardware initialization. The

diagnostics then checks the RF module to see whether it is properly runs in the AP.

And then, the firmware downloads RF module operating program.

. U

pon successful completion of the diagnostics and program download, After Radio

Link LED turns on and then turns off for a few seconds all the LED display steady

bright.

The diagnostics take approximately 30 seconds to complete after power-up. Upon

successful completion of the diagnostics, the LED pattern shown in below figure is

displayed.

If the AP fails to display the proper LED pattern, verify that you have correctly installed

the AP. If the AP still fails to display the LED pattern, refer to troubleshooting section.