Revision: 1.0 AR-N8601 Installation Guide Revision 1.
Revision: 1.0 Contents 1 Introduction to AR-N8601...............................................................................................3 1.1 Specifications ..........................................................................................................3 1.2 Packing List ............................................................................................................4 1.3 System Dissection .........................................................................................
Revision: 1.0 1 Introduction to AR-N8601 Acrosser's Microbox Networking device AR-N8601 is a small, cost-effective and entry-level UTM (Unified Threat Management) hard ware, which is suitable for small office. Base on VIA CN700 with ULV Eden 500MHz CPU, the AR-N8601 general very low heat. We also put a quiet Fan to keep the low noise which will not cause uncomfortable voice. By three 10/100 Lans, the AR-N8601 is sufficient for the small business security hardware solution. Key features: 1.
Revision: 1.0 1.2 Packing List Description Quantity AR-N8601 1 Console cable 1 Software driver CD 1 Quick user’s manual 1 Screw pack 1 Power adaptor 1 Power cord 1 SATA cable 1 SATA power cable 1 1.
Revision: 1.
Revision: 1.
Revision: 1.0 2 Procedures of Assembly/Disassembly 2.1 Installing the 2.5” Hard Disk Drive (HDD) Follow this guide to install a 2.5” HDD step-by-step. 1. Unfasten four screws of chassis top cover and open it.
Revision: 1.0 (c) Open chassis top cover 2. Put the 2.5” HDD on the hard disk bracket and using four screws fasten it.
Revision: 1.0 3. Connect SATA & power cables of HDD to the correct positions. 4. Note that you can use the cable tie to fasten these cables. To avoid these cables is too confused. 5. Finally, assemble the top cover and fasten it with screws.
Revision: 1.0 2.2 Installing the CF card. 1. Unfasten four screws of chassis top cover and open it. 2. Insert the CF card into the CF socket. 3. Finally, assemble the top cover and fasten it with screws. Appendix You should take apart the HDD bracket first if you want to replace the SDRAM.
