Revision: 1.0 AR-N5205A System Guide Revision 1.
Revision: 1.0 Contents 1. Introduction of AR-N5205A ...................................................... 3 1.1 Specifications.................................................................................... 4 1.2 Packing List....................................................................................... 4 1.3 System Dissection ............................................................................ 5 2. Procedure of Assembly/Disassembly ......................................
Revision: 1.0 1. Introduction of AR-N5205A AR-N5205A is the mainstream level network platforms solutions that use Intel chipsets and support for Celeron M / Pentium M processors up to 1.8GHz providing exceptional performance. Furthermore, by leveraging the PCI Express technology both provide total of four onboard PCI-E x1 GbE ports plus two PCI GbE ports to maximize network bandwidth.
Revision: 1.0 1.1 Specifications Item Description System AR-N5205A Series CPU Board AR-B5205 System Dimensions 229*44*183(mm) 1.2 Packing List Description Q’ty AR-N5205A 1 Power Core 1 Power Adaptor 1 CD 1 SATA Power Cable 1 SATA Cable 1 KB/MS Cable 1 QuIck user manual 1 2.
Revision: 1.0 1.
Revision: 1.
Revision: 1.0 2. Procedure of Assembly/Disassembly 2-1 Installing the 2.5”Hard Disk Drive (HDD) The following are step-by-step installation 1. Remove the power cord out from the AR-N5205A 2. Unscrew the two screws in top cover of AR-N5205A.
Revision: 1.0 3. Release the top cover follows the direction. Push Push 4. Place HDD body into HDD bracket and lock HDD body and bracket by screws (4pcs). 5. Insert the rubbers into the HDD bracket.
Revision: 1.0 Install the rubbers on the HDD bracket. 6. Connect SATA cable to HDD module (HDD+HDD bracket) 7. Place HDD module back to the case 8. Lock HDD module to the chassis by four screws and connect the HDD with SATA cable and Power cable.
Revision: 1.
Revision: 1.0 9. Finish the installation by lock the two screws in top cover of AR-N5205A.
Revision: 1.0 2-2 Installing CF, mini PCI and SO-DIMM cards The following are step-by-step installation 1. Remove the extending doors by removing the screws, as shown below. Unscrew when installing the mini-PCI Card . Warning Label Unscrew when installing the SO-DIM or CF card. Remove the extending doors by removing the screws.
Revision: 1.0 Appendix NOTICE: Please don't change CPU by yourself. Any disassembly and assembly for the CPU thermal module will cause unexpected damage. Please do contact Acrosser customer survice center/FAE in case changing CPU .
