Specifications

AR-B1564 User¡¦s Guide
6-1
6. INSTALLATION
This chapter describes the procedure of the installation. The following topics are covered:
l Overview
l Utility Diskette
l Watchdog Timer
6.1 OVERVIEW
This chapter provides information for you to set up a working system based on the AR-B1564 CPU card. Please
read the details of the CPU card’ s hardware descriptions before installation carefully, especially jumper setting,
switch settings and cable connections.
Follow steps listed below for proper installation:
Step 1 : Read the CPU board’ s hardware description in this manual.
Step 2 : Install any DRAM SIMM onto the CPU card.
Step 3 : Set jumpers.
Step 4 : Make sure that the power supply connected to your passive CPU board is turned off.
Step 5 : Plug the CPU card into a free AT-bus slot or PICMG slot on the backplane and secure it in place with
a screw to the system chassis.
Step 6 : Connect all necessary cables. Make sure that the FDC, HDC, serial and parallel cables are
connected to pin 1 of the related connector.
Step 7 : Connect the hard disk/floppy disk flat cables from the CPU board to the drives. Connect a power
source to each drive.
Step 8 : Plug the keyboard into the keyboard connector.
Step 9 : Turn on the power.
Step 10: Configure your system with the BIOS Setup program then re-boot your system.
Step 11: If the CPU board does not work, turn off the power and read the hardware description carefully
again.
Step 12: If the CPU board still does not perform properly, return the board to your dealer for immediate
service.
6.2 UTILITY DISKETTE
AR-B1564 provides three VGA driver diskettes, supports WIN31, WIN95, WINNT3.5, WINNT4.0 and OS/2 WARP
3.0.
There are three VGA diskettes: disk#1 is for WIN31, disk#2 is for WIN95, & OS/2, disk#3 is for WINNT3.5 &
WINNT4.0. Disk#4 is for network utility, disk#5 is for audio utility. In disk#1 to disk#4 the compressed files are
auto-extracted. In the disk#5 utility directory attached the extract program -- PKUNZIP.EXE, to extract the files in
the audio directory, including the README.TXT file in the compress file. Please refer to the file for any
troubleshooting before install the driver.