Specifications

~ Page 37 ~
4-6. PCI/PLUG AND PLAY
This section is used to configure PCI / Plug and Play features. The <PCI & PNP Setup> option configures
the PCI bus slots. All PCI bus slots on the system use INTA#, thus all installed PCI cards must be set to
this value.
AMBIOS SETUP – PCI/PLUG AND PLAY SETUP
(C) 1999 American Mega trends, Inc. All Rights Reserved
Plug and Play Aware O/S
Reset Configuration Data
PCI Latency Timer (PCI Clocks)
Primary Graphics Adapter
PCI VGA Palette Snoop
PCI IDE Bus Master
PCI Slot1 IRQ Priority
PCI Slot2 IRQ Priority
PCI Slot3 IRQ Priority
PCI Slot4 IRQ Priority
DMA Channel 0
DMA Channel 1
DMA Channel 3
DMA Channel 5
DMA Channel 6
DMA Channel 7
IRQ3
IRQ4
IRQ5
IRQ7
IRQ9
IRQ10
IRQ11
IRQ12
IRQ14
IRQ15
Reserved Memory Size
Reserved Memory Address
No
Yes
64
PCI
Disabled
Disabled
Auto
Auto
Auto
Auto
PnP
PnP
PnP
PnP
PnP
PnP
ISA/EISA
ISA/EISA
PCI/PnP
ISA/EISA
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
ISA/EISA
ISA/EISA
Disabled
C8000
Available Options:
Yes
No
ESC: Exit ,-: Sel
Pg Up/Pg Dn: Modify
F2/F3: Color
BIOS: PCI / Plug and Play Setup
Plug and Play Aware O/S
Set this option to <No> if the operating system installed in the computer is Plug and Play-aware. The BIOS
only detects and enables PnP ISA adapter cards that are required for system boot. The Windows 95 (and
above) operating system detects and enables all other PnP-aware adapter cards. Windows 95 (and above)
is PnP-aware. Set this option to <yes> if the operating system (such as DOS, OS/2, Windows 3.x) does not
use PnP. You must set this option correctly or PnP-aware adapter cards installed in your computer will not
be configured properly.
Clear NVRAM
This sets the operating mode of the boot block area of the BIOS FLASH ROM to allow programming in the
yes setting.