Specifications

~ Page 35 ~
4-5. POWER MANAGEMENT
This section is used to configure the power management features. This <Power management Setup> option
allows you to reduce power consumption. This feature turns off the video display and shuts down the hard
disk after a period of inactivity.
AMBIOS SETUP – POWER MANAGEMNT SETUP
(C) 1999 American Mega trends, Inc. All Rights Reserved
Power Management/APM
Green PC Monitor Power State
Video Power Down Mode
Hard Disk Power Down Mode
Hard Disk Time Out (Minute)
Standby Time Out (Minute)
Suspend Time Out (Minute)
Throttle Slow Clock Ratio
Modem Use IO Port
Modem Use IRQ
Display Activity
Device 6 (Serial port 1)
Device 7 (Serial port 2)
Device 8 (Parallel port)
Device 5 (Floppy disk)
Device 0 (Primary master IDE)
Device 1 (Primary slave IDE)
Device 2 (Secondary master IDE)
Device 3 (Secondary slave IDE)
System Thermal
Thermal Slow Clock Ratio
Enabled
Off
Disabled
Disabled
Disabled
Disabled
Disabled
50-62.5%
N/A
N/A
Ignore
Monitor
Monitor
Ignore
Monitor
Monitor
Ignore
Monitor
Ignore
Ignore
50-62.5%
Available Options:
Disable
Enabled
ESC; Exit ,-: Sel
Pg Up/Pg Dn; Modify
F2/F3: Color
BIOS: Power Management Setup
Power Management /APM
Enabled this option is to enable the power management and APM (Advanced Power Management) features.
Green PC Monitor Power State
This option specifies the suspend mode of shutting down the cathode ray gun, if only the system is fixed a
green function monitor, the power saving function is available.
Video Power Down Mode
This option specifies the power management state that the video subsystem enters after specified period of
display inactivity has expired.
Hard Disk Power Down Mode
This option specifies the power management states that the hard disk drive enters after the specified period
of display inactivity have expired.
Hard Disk time out (minute)
This item is used to set up the initial value of the waiting timer .the Hard Disk will turn into the suspend mode
when the time is out if no operation applied to Hard Disk.
Standby Time Out (minute)
This item is used to set up the initial value of the waiting timer, the System will turn into the suspend mode
when the time is out if no operation applied to system.