Specifications

~ Page 41 ~

5-6. PCI/PLUG AND PLAY

This section is used to configure PCI / Plug and Play features. The <PCI & PNP Setup> option configures

the PCI bus slots. All PCI bus slots on the system use INTA#, thus all installed PCI cards must be set to

this value.

BIOS: PCI / Plug and Play Setup

Plug and Play Aware O/S

Set this option to <No> if the operating system installed in the computer is Plug and Play-aware. The BIOS

only detects and enables PnP ISA adapter cards that are required for system boot. The Windows 95 (and

above) operating system detects and enables all other PnP-aware adapter cards. Windows 95 (and above)

is PnP-aware. Set this option to <yes> if the operating system (such as DOS, OS/2, Windows 3.x) does not

use PnP. You must set this option correctly or PnP-aware adapter cards installed in your computer will not

be configured properly.

Reset Configuration Data

This sets the operating mode of the boot block area of the BIOS FLASH ROM to allow programming in the

Yes setting.

PCI Latency Timer (PCI Clocks)

This option sets latency of all PCI devices on the PCI bus. The settings are in units equal to PCI clocks.

Primary Graphic Adapter

This option is set to use PCI bus or AGP. The AGP mode will get system a faster processing speed.

AMIBIOS SETUP - PCI/PLUG AND PLAY SETUP

Plug and Play Aware O/S NO Available Options

Reset Configuration Data NO NO

PCI Latency Timer (PCI Clocks) 64 YES

Primary GraphicS Adapter PCI

PCI VGA Palette Snoop Disabled

DMA Channel 0 PnP

DMA Channel 1 PnP

DMA Channel 3 PnP

DMA Channel 5 PnP

DMA Channel 6 PnP

DMA Channel 7 PnP

IRQ 3 ISA/EISA

IRQ 4 ISA/EISA

IRQ 5 PCI/PnP

IRQ 7 ISA/EISA

IRQ 9 PCI/PnP

IRQ 10 ISA/EISA

IRQ 11 ISA/EISA

IRQ 12 PCI/PnP

IRQ 14 ISA/EISA

IRQ 14 PCI/PnP

ESC:Exit ↑↓:Sel

IRQ 15 PCI/PnP PgUp/PgDn:Modify

Reserved Memory Size 32K F2/F3:Color

Reserved Memory Address CC000