User Manual

20
6.2 Supervisor Badges
Your unit includes two Supervisor Badges which allow access to the
keypad to make program changes. Place one badge in a safe place for
future or emergency use. The Time Q terminal can be programmed to
recognize a specific employee badge as a Supervisor badge (if you desire
more than one person to have program/edit access), but it can never be
programmed not to recognize the original supervisor badges. To make a
new supervisor badge:
PROGRAM FUNCTION DISPLAY SHOWS
1. Swipe Supervisor badge MAIN MENU
REPORTS
2. Scroll Main Menu Up/Down MAIN MENU
to SUPERVISOR cards
3. Press ENTER SELECT A TASK
ADD SUPERVISOR BADGE
4. Press ENTER ENTER BADGE NUMBER
0
5. Enter Badge Number ENTER BADGE NUMBER
(or swipe a badge) 3
6. Press ENTER 0003
enter to confirm
7. Press ENTER
Unit beeps twice to accept. The employee badge now
functions as a supervisor badge.
Functions
6.1 Introduction
This section will walk you through an example of each function.
NOTE: At any point one can back out of any MENU by repeatedly
pressing the CLEAR key.
The display has two lines of characters.Aflashing display typically
indicates you can use the menu keys to access another option. Flashing
characters are enclosed within .
6. Functions