user manual

12. Remove the cam gear, reduction gear, change gear and gear guide
12-1 12-2
12-3 12-4
1.Remove the motor gear.(12-1)
2.Remove one screw to r emove the Lever Holding Spring(12-2)
3.Pull the cam gear out of the shaft , Inset a standard type screwdriver into the gap
between the cam gear and frame, and left the cam gear. Be careful m ot to press the
screwdriver against the shaft from the side.
4.Remove the reduction gear in the same as shown in above step. The change gear
and gear guide are also remove with the reduction gear.