User manual

25
In order to use a bell or horn a relay is required. Please call Acroprint or your Dealer to order the
relay (PN 01-0230-000).
When a signal is activated by the clock the internal contacts of the relay close and complete the
circuit. These internal contacts are "dry" and supply no voltage. Voltage applied to these
contacts must not exceed 30 volts. The relay then activates the 120v external signal device such
as:
65-0103-000 "Grille Horn"
65-0104-000 "4-1/4" Bell"
65-0105-000 "8" Bell"
For more information about connecting an external signal device using a relay go to
http://support.acroprint.com
Under “Time Clocks & Document Stamps” click on “ATR360 Time Clock” in the drop down menu
and download 06-0346-000 “Connecting an External Signal Device”.
Wall Mounting Instructions
The ATR360 can be placed on a table or desk and it can also be mounted to a wall. A mounting
template is included with the documents for the ATR360. If you misplace the template you can
download it at:
http://support.acroprint.com
Under “Time Clocks & Document Stamps” click on “ATR360 Fingerprint Clock” in the drop down
menu.
Follow the instructions on the template to mount the clock.
Fingerprint Privacy
1. The ATR360 merely captures points of the fingerprint but not the actual fingerprint image.
2. The fingerprint points cannot be used to create a fingerprint
image.
3. Acroprint will not be liable for any direct or indirect damages resulting from the use or inability
to use the clock.
4. If you have a question about privacy concerning the use of the clock you should have your
employer contact Acroprint.