User manual

11
Editing Shift Intervals
1. Open clock lid. Press "FP Setup" button
2. Press "down" until the LED display shows "InO.S". Press "Enter". "PE.1” will be displayed.
Press "up/down" if you want to edit a different shift.
Press "Enter" to select the shift to edit. Edit the Start of Shift time (hrs : min). Press and hold
"Enter" for 3 sec. to set the Start time ("Pass" will be displayed indicating the start time was
correctly set).
Now edit the Start minute if necessary. Press and hold "Enter" for 3 sec. to
set the Start time.
3. Press "Up" or "Down" to select additional shifts for editing.
Deleting a User’s Badge Number
1. Open clock lid and press "FP Setup".
2. "Add.U" is displayed.
3. Press “Down”. "dEL.U" is displayed.
4. Press “Enter”. Select the User/Admin to delete then press and hold “Enter” for 3 sec.
5. F.P.1 will flash (if the user has fingerprints enrolled). Press “Up” (skipping all fingerprints)
until “rFId” is displayed. Press “Enter”. If the badge is successfully deleted the LED display
will show “PASS”.
6. Press “FP Setup” & “Up”. “End.P” is displayed. Press “Enter” to exit FP Setup mode.
Set Ink Color Change Time
1. Remove top cover
2. Locate the program switch to the left of the finger print reader. Move the switch to the down
position, you are now in setup mode
3. Press P1.
a. P1,P4,P5,P6 will now be flashing
4. If this is the initial setup you must begin with 01
5. Press P6 to save
6. Press P4 or P5 to select the correct hour
7. Press P6 to save
8. Press P4 or P5 to select the correct minute
9. Press P6 to save
10. Press P4 or P5 to select the correct color
a. 01 – Black
b. 02 – Red
11. Press P6 to save
12. Deselect days by pressing P4 or P5 to highlight the day. Press P1 to deselect the day. After
P1 is pressed the day will disappear
a. 7 = Sunday, 1 = Monday….
b. To reselect the day’s press P4 or P5 until the day is flashing then press P1
13. Press P6 to save
14. Complete steps 5-13 to complete the remaining 11 slots or to exit setup move the program
switch to the up position