User manual

TR510 (from GIGA-TMS)
Install TR510 communication software as described in TR510 manual.
Create C:\TR4000 folder.
Make sure that the IP address of the reader is properly associated with the reader (000-Default
or 001-Machine-1 etc) in Settings. Test with Ping to check proper communication.
In the ‘Time Scheduler’ page make sure settings in the fields circled with red colour are as
shown below. If ID digits set is showing 15, change it to 14 (it can be done when ’Save type’
field is showing ‘default’).
Configure ‘By Interval’ or ‘By Table’ as required.
Clicking Start button transfers data from readers to PC.
Proxy ID Length must be configured as 14 in TAS2000 – Interface to Post Data.
In Interface to Post Data configuration, select TR4000 from Giga-Tms/Promag in the
Attendance Reader Interface parameter.
SHIFT KEY length. Make it 0 (zero) in “Interface To Post Data” configuration
TR550 (from GIGA-TMS)
Install communication software as described in TR550 manual.
Create C:\TR4000 folder.
Setup serial or modem configuration as per the manual and your requirements.
Ensure all file transfer details as described above for TR510.
Proxy ID Length must be configured as 14 in TAS2000 – Interface to Post Data.
In Interface to Post Data configuration, select TR4000 from Giga-Tms/Promag in the
Attendance Reader Interface parameter.
SHIFT KEY length. Make it 0 (zero) in “Interface To Post Data” configuration
You can also use F1/F2/F3/F4 keys to show reason for going In/Out.
Part 7