User's Manual

Configuring procedure for selecting the READERS:

Swipe the Configuration Badge 000000000

(This badge is provided with each terminal.)

(Select any combination 1234 to activate the readers. 1 for Internal Barcode, 2

for External Barcode, 3 for Internal Magnetic Stripe and 4 for Internal Proximity

Reader) Note, if 4 is selected then the External Barcode Reader will be disabled.

Note, if you turned OFF all readers you will be unable to read the configuration

badge. The following procedure will allow you to re-enable the readers. Press

the IN, then the OUT and then the ENTER key within 1 second. The terminal

will go into a testing mode. Press the Clear key followed by Press the IN, then

the OUT and then the ENTER key within 1 second or before the time is

displayed.