Server for Linux
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Acronis True Image Echo Server installation and startup
- Chapter 3. General information and proprietary Acronis technologies
- 3.1 The difference between file archives and disk/partition images
- 3.2 Full, incremental and differential backups
- 3.3 Acronis Secure Zone®
- 3.4 Working from a rescue CD
- 3.5 Working from a remote terminal
- 3.6 Backing up software and hardware RAID arrays
- 3.7 Support for LVM volumes
- 3.8 Backing up to tape drive
- Chapter 4. The program interface under X Window System
- Chapter 5. Creating backup archives
- Chapter 6. Restoring the backup data under X Window system
- 6.1 Considerations before recovery
- 6.2 Restoring files and folders from file archives
- 6.3 Restoring disks/partitions or files from images
- 6.3.1 Starting the Restore Data Wizard
- 6.3.2 Archive selection
- 6.3.3 Restoration type selection
- 6.3.4 Selecting a disk/partition to restore
- 6.3.5 Selecting a target disk/partition
- 6.3.6 Changing the restored partition type
- 6.3.7 Changing the restored partition file system
- 6.3.8 Changing the restored partition size and location
- 6.3.9 Restoring several disks or partitions at once
- 6.3.10 Setting restore options
- 6.3.11 Restoration summary and executing restoration
- 6.4 Restoring data with a rescue CD
- 6.5 Setting restore options
- Chapter 7. Scheduling tasks
- Chapter 8. Managing Acronis Secure Zone
- Chapter 9. Creating bootable media
- Chapter 10. Operations with archives
- Chapter 11. Notifications and event tracing
- Chapter 12. Console mode
- Chapter 13. Transferring the system to a new disk
- 13.1 General information
- 13.2 Security
- 13.3 Executing transfers
- 13.3.1 Selecting Clone mode
- 13.3.2 Selecting source disk
- 13.3.3 Selecting destination disk
- 13.3.4 Partitioned destination disk
- 13.3.5 Old and new disk partition layout
- 13.3.6 Old disk data
- 14.3.7 Destroying the old disk data
- 13.3.8 Selecting partition transfer method
- 13.3.9 Partitioning the old disk
- 13.3.10 Old and new disk partition layouts
- 13.3.11 Cloning summary
- 13.4 Cloning with manual partitioning
- Chapter 14. Adding a new hard disk
If the cursor turns to two vertical lines with left and right arrows, it is pointed at the
partition border and you can drag it to enlarge or reduce the partition size. If the cursor
turns to four arrows, it is pointed at the partition, so you can move it to the left or right (if
there is unallocated space near it). Having provided the new partition location and size,
you can input a label for the new partition.
If you make a mistake at partitioning, click Back to redo the process.
Finally, you will be taken back to the partition layout screen. Check the resulting partitions
layout and start creating another partition or move on by unchecking Create new
partition in unallocated space and clicking Next.
14.3 Disk add summary
The disk add summary contains a list of operations to be performed on disks.
After you click Proceed, Acronis True Image Echo Server will start creating and
formatting new partitions, indicating the progress in a special window. You can stop this
procedure by clicking Cancel. In that case, you will have to repartition and format the
new disk or repeat the disk add procedure.