Server for Linux
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Acronis True Image Echo Server installation and startup
- Chapter 3. General information and proprietary Acronis technologies
- 3.1 The difference between file archives and disk/partition images
- 3.2 Full, incremental and differential backups
- 3.3 Acronis Secure Zone®
- 3.4 Working from a rescue CD
- 3.5 Working from a remote terminal
- 3.6 Backing up software and hardware RAID arrays
- 3.7 Support for LVM volumes
- 3.8 Backing up to tape drive
- Chapter 4. The program interface under X Window System
- Chapter 5. Creating backup archives
- Chapter 6. Restoring the backup data under X Window system
- 6.1 Considerations before recovery
- 6.2 Restoring files and folders from file archives
- 6.3 Restoring disks/partitions or files from images
- 6.3.1 Starting the Restore Data Wizard
- 6.3.2 Archive selection
- 6.3.3 Restoration type selection
- 6.3.4 Selecting a disk/partition to restore
- 6.3.5 Selecting a target disk/partition
- 6.3.6 Changing the restored partition type
- 6.3.7 Changing the restored partition file system
- 6.3.8 Changing the restored partition size and location
- 6.3.9 Restoring several disks or partitions at once
- 6.3.10 Setting restore options
- 6.3.11 Restoration summary and executing restoration
- 6.4 Restoring data with a rescue CD
- 6.5 Setting restore options
- Chapter 7. Scheduling tasks
- Chapter 8. Managing Acronis Secure Zone
- Chapter 9. Creating bootable media
- Chapter 10. Operations with archives
- Chapter 11. Notifications and event tracing
- Chapter 12. Console mode
- Chapter 13. Transferring the system to a new disk
- 13.1 General information
- 13.2 Security
- 13.3 Executing transfers
- 13.3.1 Selecting Clone mode
- 13.3.2 Selecting source disk
- 13.3.3 Selecting destination disk
- 13.3.4 Partitioned destination disk
- 13.3.5 Old and new disk partition layout
- 13.3.6 Old disk data
- 14.3.7 Destroying the old disk data
- 13.3.8 Selecting partition transfer method
- 13.3.9 Partitioning the old disk
- 13.3.10 Old and new disk partition layouts
- 13.3.11 Cloning summary
- 13.4 Cloning with manual partitioning
- Chapter 14. Adding a new hard disk
If you added a comment to the archive, it will be displayed to the right of the drives tree.
If the archive was protected with a password, Acronis True Image Echo Server will ask for
it. Neither the partitions layout, nor the Next button will be enabled until you enter the
correct password.
3. If you selected an archive containing incremental images, Acronis True Image Echo
Server will suggest that you select one of the successive incremental images by its
creation date/time. Thus, you can explore the partition state to a certain moment.
To mount an incremental image, you must have all previous incremental images and the
initial full image. If any of the successive images are missing, mounting is not possible.
To mount a differential image, you must have the initial full image as well.
4. Select a partition to mount (note that you cannot mount the entire disk) and specify
the mount point for the selected partition.
Copyright © Acronis, Inc., 2000-2008