Datasheet

Dynamic volumes are specified with prefix DYN, e.g.:
/file_partition:DYN1 /filename:”\1.tib”
/harddisk:[disk number]
Specifies the basic hard disks to restore.
/partition:[partition
number]
Specifies the partitions to restore.
Dynamic volumes are specified with prefix DYN, e.g.:
/partition:DYN1
/target_harddisk:[disk
number]
Specifies the hard disk number where the image will be restored.
By specifying
/target_harddisk:DYN
you will select unallocated space on all dynamic disks that present
in the system.
/target_partition:[partiti
on number]
Specifies the target partition number for restoring a partition over
the existing one. If the option is not specified, the program assumes
that the target partition number is the same as the partition number
specified with the
/partition option.
Dynamic volumes are specified with prefix DYN, e.g.:
/target_partition:DYN1
/start:[start sector]
Sets the start sector for restoring a partition to the hard disk
unallocated space.
/size:[partition size in
sectors]
Sets the new partition size (in sectors).
/fat16_32
Enables the file system conversion from FAT16 to FAT32 if the
partition size after recovery is likely to exceed 2GB. Without this
option, the recovered partition will inherit the file system from the
image.
/type:[active | primary |
logical]
Sets the restored partition active, primary or logical, if possible (for
example, there cannot be more than four primary partitions on the
disk.) Setting a partition active always sets it primary, while a
partition set primary may stay inactive.
If the type is not specified, the program tries to keep the target
partition type. If the target partition is active, the restored partition
is set active. If the target partition is primary, and there are other
primary partitions on the disk, one of them will be set active, while
the restored partition becomes primary. If no other primary
partitions remain on the disk, the restored partition is set active.
When restoring a partition on unallocated space, the program
extracts the partition type from the image. For the primary
partition, the type will be set as follows:
- if the target disk is the 1st according to BIOS and it has not other
primary partitions, the restored partition will be set active
- if the target disk is the 1st according to BIOS and there are other
primary partitions on it, the restored partition will be set logical
- if the target disk is not the 1st, the restored partition will be set
logical.
/preserve_mbr
When restoring a partition over an existing one, the target partition
is deleted from the disk along with its entry in the target disk MBR.
Then, with the
/preserve_mbr option, the restored partition’s entry
will occupy the upper empty position in the target disk MBR. Thus,
the target disk MBR is preserved. If not specified, the restored
Copyright © Acronis, Inc., 2000-2007 141