Administrator’s Command Line Guide
Table Of Contents
- Introduction
- Accessing Acronis Storage Clusters via iSCSI
- Preparing to Work with Acronis Storage iSCSI Targets
- Creating and Running Acronis Storage iSCSI Targets
- Listing Acronis Storage iSCSI Targets
- Transferring Acronis Storage iSCSI Targets Between Acronis Storage Nodes
- Stopping Acronis Storage iSCSI Targets
- Deleting Acronis Storage iSCSI Targets
- Configuring Multipath I/O for Acronis Storage iSCSI Targets
- Managing CHAP Accounts for Acronis Storage iSCSI Targets
- Managing LUN Snapshots
- Accessing Acronis Storage Clusters via S3 Protocol
- Monitoring Acronis Storage Clusters
- Managing Cluster Security
- Maximizing Cluster Performance
CHAPTER 1
Introduction
This chapter provides basic information about this guide and Acronis Storage.
1.1 About This Guide
This guide complements documentation on managing Acronis Storage via the web-based management panel.
It is recommended to manage Acronis Storage via the management panel. If you have it installed, consider
the command-line tools secondary and use them with caution.
If you have the management panel installed, do not do the following via the command-line tools:
• set custom paths for Acronis Storage services, in particular:
•
create S3 clusters only in /mnt/vstorage/vols/s3,
•
create iSCSI targets only in /mnt/vstorage/vols/iscsi,
• mount clusters or change cluster mount options,
• configure firewall with firewall-cmd,
• rename network connections,
• manage MDS/CS,
• manage partitions, LVMs, or software RAID,
• modify files in /mnt/vstorage/vols and /mnt/vstorage/webcp/backup directories,
• set encoding or replication of cluster root.
1