Administrator’s Command Line Guide
Table Of Contents
- Introduction
- Accessing Acronis Storage Clusters via iSCSI
- Preparing to Work with Acronis Storage iSCSI Targets
- Creating and Running Acronis Storage iSCSI Targets
- Listing Acronis Storage iSCSI Targets
- Transferring Acronis Storage iSCSI Targets Between Acronis Storage Nodes
- Stopping Acronis Storage iSCSI Targets
- Deleting Acronis Storage iSCSI Targets
- Configuring Multipath I/O for Acronis Storage iSCSI Targets
- Managing CHAP Accounts for Acronis Storage iSCSI Targets
- Managing LUN Snapshots
- Accessing Acronis Storage Clusters via S3 Protocol
- Monitoring Acronis Storage Clusters
- Managing Cluster Security
- Maximizing Cluster Performance
Chapter 4. Monitoring Acronis Storage Clusters
The command above shows the latest events in the stor1 cluster. The information on events (highlighted in
red) is given in the table with the following columns:
Column Description
TIME Time when the event happened.
SYS Component of the cluster where the event happened (e.g., MDS for an MDS server or
JRN for local journal).
SEV Event severity.
MESSAGE Event description.
4.6.1 Exploring Basic Events
The table below describes the basic events displayed when you run the vstorage top utility.
54