Administrator’s Command Line Guide
Table Of Contents
- Introduction
- Accessing Acronis Storage Clusters via iSCSI
- Preparing to Work with Acronis Storage iSCSI Targets
- Creating and Running Acronis Storage iSCSI Targets
- Listing Acronis Storage iSCSI Targets
- Transferring Acronis Storage iSCSI Targets Between Acronis Storage Nodes
- Stopping Acronis Storage iSCSI Targets
- Deleting Acronis Storage iSCSI Targets
- Configuring Multipath I/O for Acronis Storage iSCSI Targets
- Managing CHAP Accounts for Acronis Storage iSCSI Targets
- Managing LUN Snapshots
- Accessing Acronis Storage Clusters via S3 Protocol
- Monitoring Acronis Storage Clusters
- Managing Cluster Security
- Maximizing Cluster Performance
4.6. Monitoring Event Logs
The disks table shows the following parameters:
Parameter Description
DISK Disk name assigned by operating system.
SMART Disk’s S.M.A.R.T. status:
• OK: The disk is healthy.
• Warn: The disk is in pre-failure condition.
Pre-failure condition means that at least one of these S.M.A.R.T. counters is nonzero:
• Reallocated Sector Count
• Reallocated Event Count
• Current Pending Sector Count
• Offline Uncorrectable
TEMP Disk temperature in Celsius.
CAPACITY Disk capacity.
SERIAL Disk serial number.
MODEL Disk model.
HOST Disk’s host address.
Note: To disable S.M.A.R.T. disk monitoring, delete the corresponding cron job.
4.6 Monitoring Event Logs
You can use the vstorage -c <cluster_name> top utility to monitor significant events happening in a Acronis Storage
cluster, for example:
53