Administrator’s Command Line Guide
Table Of Contents
- Introduction
- Accessing Acronis Storage Clusters via iSCSI
- Preparing to Work with Acronis Storage iSCSI Targets
- Creating and Running Acronis Storage iSCSI Targets
- Listing Acronis Storage iSCSI Targets
- Transferring Acronis Storage iSCSI Targets Between Acronis Storage Nodes
- Stopping Acronis Storage iSCSI Targets
- Deleting Acronis Storage iSCSI Targets
- Configuring Multipath I/O for Acronis Storage iSCSI Targets
- Managing CHAP Accounts for Acronis Storage iSCSI Targets
- Managing LUN Snapshots
- Accessing Acronis Storage Clusters via S3 Protocol
- Monitoring Acronis Storage Clusters
- Managing Cluster Security
- Maximizing Cluster Performance
4.4. Monitoring Clients
The command above shows detailed information about the stor1 cluster. The monitoring parameters for clients
(highlighted in red) are explained in the table below:
Parameter Description
CLID Client identifier (ID).
LEASES Average number of files opened for reading/writing by the client and not yet closed,
for the last 20 seconds.
READ Average rate, in bytes per second, at which the client reads data, for the last 20 seconds.
WRITE Average rate, in bytes per second, at which the client writes data, for the last 20 sec-
onds.
RD_OPS Average number of read operations per second the client made, for the last 20 seconds.
WR_OPS Average number of write operations per second the client made, for the last 20 sec-
onds.
FSYNCS Average number of sync operations per second the client made, for the last 20 seconds.
IOLAT Average/maximum time, in milliseconds, the client needed to complete a single IO op-
eration, for the last 20 seconds.
HOST Client hostname or IP address.
51