User guide

137 Copyright © Acronis International GmbH, 2002-2012.
/log:<file name>
Creates a log file of the current operation
with the specified file name
Any
/log_net_user:<remote user>
If the log file is created in a network
folder, specifies the user name for
accessing that folder
Any
/log_net_password:<password
>
If the log file is created in a network
folder, specifies the password fo
r
accessing that folder
Any
14.1.3 Specific parameters (parameters specific for individual
commands)
Option Description
create
/harddisk:<disk
number>
Specifies the hard disks to include into the image.
An image may contain data of more than one hard disk. In
that case,
separate disk numbers by commas, for example:
/harddisk:1,3
To view the list of available hard disks, use the
/list
command.
/partition:<disk
number>-<volume
number>
Specifies the volumes to include into the image file.
Volume numbers are specified as <disk number>-
<volume
number>, for example:
/partition:1-1,1-2,3-1
See also the /oss_numbers parameter.
To view the list of available volumes, use the
/list
command.
/raw
Use this parameter to create an image of a volume with an
unrecognized or
unsupported file system, or of a disk that contains
such volume.
With this parameter, all contents of the disk or volume will be copied
sector-by-sector.
Without this parameter, only the sectors containing useful system and
user data are imaged (for the supported file systems).
/progress:<on|off>
Shows or hides the progress information (percent completed). The
progress is shown by default.
deploy
/harddisk:<disk
number>
Specifies the hard disk in the image.
/partition:<disk
number>-<volume
number>
Specifies the volumes in the image.
/target_harddisk:<disk
number>
Specifies the target hard disk.
/target_partition:<vol
ume number>
Specifies the target volume number for deploying a volume over an
existing one. If this parameter is not specified, the softwa
re assumes