Replication Manual

24
 The local storage path you specified is wrong
The test will not perform any real replication, but because it does check the communication
between all involved components it can take a few seconds up to a minute to complete.
When the system reports an error, it will be transient and not stored. This means that if the Status
was e.g. 'Active' before you ran the test, and the test returns Error, the value that is stored will still
be Active.
Note: Be aware that the test uses the configuration fields that are currently filled in for the
replication task, even if these fields are not saved yet. It does however use the saved settings of
the selected replication destination.
6.3 Monitoring replication
You can monitor the progress and status of all replication tasks from the Management Console
in the ‘Replication Status’ tab.
Select ‘Server’ in the menu, then select ‘Replication Settings’, and select the ‘Replication status’
tab.
6.3.1 Overview
The Replication tab displays an overview of the status of all replication tasks. It displays the
following information:
 Storage location name: The name of the storage location that is handled by this task.