Replication Manual

22
 Not Configured: The task is created by the server but was not configured by the
administrator yet.
 Inactive: The task is configured but not active, meaning it won’t run.
 Active: The task is active; meaning it will run.
 Error: There is an error with the configuration of the task. An error message will be
displayed below the overview fields. Make the necessary changes in the configuration
(this might imply changes to the systems where the Replication Client and/or
Replication Server are installed). After you corrected the problem you can try the ‘Run
configuration test’ button to test the configuration.
 The ‘Run Configuration Test’ button. This enables you to test if the current configuration is
working correctly. See here for more details.
 You can expand the overview line to see and edit the configuration of the task.
6.2.2 Edit replication tasks
To edit a replication task, expand the corresponding task in the overview on the ‘Replication
Configuration’ tab, make the necessary changes, and press ‘Update’ to save your changes. Please
note that by pressing ‘Update’ you save changes made to any of the replication tasks.
When saving your changes, the system will perform some input validations like mandatory fields
and provide feedback if necessary. It will however not automatically check if the configuration is
valid and functioning. To do this you can test the configuration before saving.
The following fields can be edited: