Installation Procedure

ManualsBrandsAcronis ManualsApplicationsBackupAgent Server

Server Installation Procedure

1. Introduction

This document explains a step-by-step procedure in case BackupAgent BV performs an

installation of the BackupAgent Server Software on the hardware of a customer. The document

also describes which conditions must be met by the customer before BackupAgent can perform

an installation.

Note: This specific document applies to the situation where the software is installed on one

machine.

2. Prerequisites met by customer

A BackupAgent engineer will reserve a time slot for the performance of the installation. This

time will be communicated with the customer. Therefore is very important that the following

conditions are met by the customer before the BackupAgent engineer starts with the

installation procedure.

Note: In case the customer does not meet the prerequisites as described in this document,

BackupAgent will not start with or discontinue the installation procedure as soon as this failure

is detected.

Note: A discontinued installation is considered to be completed in case no continuation of the

installation procedure was possible within four hours after the discontinuation.

2.1 Hardware requirements

The hardware on which the BackupAgent Server Software will be installed must comply with the

following minimal requirements:

 3 Ghz Quad Core or higher/comparable processor

 8 GB available RAM

 300 MB of disk space

Summary of content (4 pages)

PAGE 1
Server Installation Procedure 1. Introduction This document explains a step-by-step procedure in case BackupAgent BV performs an installation of the BackupAgent Server Software on the hardware of a customer. The document also describes which conditions must be met by the customer before BackupAgent can perform an installation. Note: This specific document applies to the situation where the software is installed on one machine. 2.
PAGE 2
.2 Software requirements The following software must be installed on the machine, before the BackupAgent engineers will start the installation:  Windows Server 2008 R2 SP1 Standard 64bit or Windows 2012 (English language only)  Latest updates and service packs of Windows  IIS 7 or IIS 8  .Net Framework 3.5 Service Pack 1 and ASP.Net (Windows component)  .Net Framework 4.5 2.
PAGE 3
 A unique domain name should be available on the machine and should resolve to the machine for port 80 and 443.  The remote connection for the installation procedure should be available for the BackupAgent employee (For RDP connections port 3389 is the default port) (The source IP of BackupAgent is 31.223.163.33 and 83.163.40.89  An SSL certificate should be installed on the machine in IIS for the domain name provided by the customer. 2.
PAGE 4
BackupAgent will deliver a fully operational Backup Server. The following is meant by ‘fully operational’:  All steps as specified above have been completed successfully  In a browser on the local machine, the Management Console is visible when browsing to ‘https://localhost/managementconsole’ and logging in to this Management Console as an Administrator  One created test-user is visible in the Management Console. 5.