Operation Manual

 If the disk mapping fails, recover the machine as described in "Recovering disks by using

bootable media" (p. 41). The media enables you to choose disks for recovery and to map the

disks manually.

5. Click Start recovery.

6. Confirm that you want to overwrite the disks with their backed-up versions. Choose whether to

restart the machine automatically.

The recovery progress is shown on the Activities tab.

2.9.3.2 Physical machine to virtual

This section describes recovery of a physical machine as a virtual machine by using the web interface.

This operation can be performed if at least one Agent for VMware or Agent for Hyper-V is installed

and registered.

For more information about P2V migration, refer to "Machine migration" (p. 54).

To recover a physical machine as a virtual machine

1. Select the backed-up machine.

2. Click Recovery.

3. Select a recovery point. Note that recovery points are filtered by location.

If the machine is offline, the recovery points are not displayed. Do any of the following:

 If the backup is located in the cloud storage, click Select machine, select a machine that is

online, and then select a recovery point.

 Select a recovery point on the Backups tab (p. 48).

 Recover the machine as described in "Recovering disks by using bootable media" (p. 41).

4. Click Recover > Entire machine.

5. In Recover to, select Virtual machine.

6. Click Target machine.

a. Select the hypervisor (VMware ESXi or Hyper-V).

At least one Agent for VMware or Agent for Hyper-V must be installed.