User manual

9 Copyright © Acronis International GmbH, 2002-2013
 In Computer name, change or specify the name that the machine will have on the network.
This is the name defined in the guest operating system (Control panel > System > System
Properties > Computer Name).
 In Network adapters, change or specify the settings for the machine's network adapters.
 In Preserve MAC addresses, specify whether the machine's network adapters will have the
same MAC addresses as those of the original machine. To prevent a MAC address conflict,
avoid selecting this check box if the original machine exists and will not be overwritten.
7. [Optional] Select the Power on the virtual machine after recovery check box.
8. Click OK.
Monitoring the recovery progress
The progress of recovery is shown in the machine details area on the right.
If you need to stop the recovery, click the stop button ( ) near the progress bar.
After the recovery is completed, the information about its success or failure is shown in the machine
details area.
1.4.6 Monitoring protection statuses
The Protection status column on the organization tab indicates how well a virtual machine or a vApp
is protected.
Protection statuses of machines
The table below lists protection statuses of a machine by order of severity, from the least severe to
the most severe.
Status
Meaning
Not protected
No backup plan is applied to the machine.
Never backed up
A backup plan is applied to the machine, but no backup has been run.
OK
A backup plan is applied to the machine and the latest backup was completed
successfully.
Error
A backup plan is applied to the machine, and the latest backup failed.
Instead of these statuses, the Backing up… or Recovering… status is shown when a backup operation
or a recovery operation is running.
Protection statuses of vApps
The protection status of a vApp is the most severe status among the machines in the vApp. This
status does not depend on whether a machine is currently being backed up or recovered.