User Guide

ManualsBrandsAcronis ManualsOtherBACKUP RECOVERY 10 SERVER FOR LINUX

Post-data capture command

To specify a command/batch file to be executed after data capture

1. In the Command field, type a command or browse to a batch file. The program does not support

interactive commands, i.e. commands that require user input (for example, "pause".)

2. In the Working directory field, specify a path to a directory where the command/batch file will be

executed.

3. In the Arguments field specify the command’s execution arguments, if required.

4. Depending on the result you want to obtain, select the appropriate options as described in the

table below.

5. Click Test command to check if the command is correct.

Check box Selection

Fail the task if the command

execution fails

Selected Cleared

Do not back up until the

command execution is

complete

Selected Selected

Cleared Cleared

Result

Preset

Continue the

backup only after

the command is

successfully

executed. Delete

the TIB file and

temporary files and

fail the task if the

command execution

fails.

Continue the

backup after the

command is

executed despite

command

execution failure

or success.

N/A Continue the

backup

concurrently

with the

command

execution and

irrespective of

the command

execution result.

3.3.1.5. File-level backup snapshot

This option is effective only for file-level backup in Windows and Linux operating systems.

This option defines whether to back up files one by one or by taking an instant data snapshot.

Note: Files that are stored on network shares are always backed up one by one.

The preset is: Create snapshot if it is possible.

Select one of the following:

• Always create a snapshot

The snapshot enables backing up of all files including files opened for exclusive access. The files

will be backed up at the same point in time. Choose this setting only if these factors are critical,

that is, backing up files without a snapshot does not make sense. To use a snapshot, the backup

plan has to run under the account with the Administrator or Backup Operator privileges. If a

snapshot cannot be taken, the backup will fail.