Installation guide

recovered databases. This is required for manual configuration or resumption of cluster

replication after recovery.

Notes for recovering mailboxes or public folders:

 When recovering mailboxes, public folders or their contents, configure the settings as

described in the "Recovering mailboxes, public folders and their contents to the Exchange

server" (p. 36) section.

5. Under When to recover, specify when to perform the recovery.

6. Click OK to start the recovery task (if it is set to run immediately) or to save the recovery task (if it

is set to run later).

Using a similar procedure, you can configure the recovery when the console is directly connected to

a cluster node. The steps are the same except that the Browse field is not displayed. The data will be

recovered onto this node.

Important: After recovery of storage groups in the CCR configuration (Exchange 2007) or databases

in the DAG configuration (Exchange 2010 or later), you need to manually configure or resume

replication on the cluster. For detailed instructions, refer to the following articles:

 Resuming replication in the CCR configuration (Exchange 2007) -

http://technet.microsoft.com/en-us/library/bb124706%28v=exchg.80%29.aspx

 Configuring or resuming replication in the DAG configuration (Exchange 2010 or later) -

http://technet.microsoft.com/en-us/library/dd298080.aspx

8.6 Cluster credentials

To access the Exchange cluster data, a domain user account that has administrative privileges on

each of the cluster nodes is required. The credentials are specified when adding a cluster node to the

management server, during backup plan creation, or during recovery task creation.

Specify:

 User name. When entering the name of an Active Directory user account, be sure to also specify

the domain name (DOMAIN\Username or Username@domain).

 Password. The password for the account.

If the credentials are detected as missing or invalid, you will receive the respective alert. To provide

valid credentials, click Fix the issue in the alert. Also, you can provide cluster credentials at the next

backup or recovery.