Operation Manual

209 Copyright © Acronis International GmbH, 2002-2015
the data stored on tapes. The archives detected as a result of the operation are placed in the
specified vault.
Within one operation, you can rescan tapes of one pool. Only online tapes can be selected for the
operation.
Run the rescanning:
 If the database of a storage node or managed machine is lost or damaged.
 If information about a tape in the database is out of date (for example, a tape contents were
modified by another storage node or agent).
 To obtain access to backups stored on tapes when working under bootable media.
 If you have mistakenly removed (p. 211) the information about a tape from the database. When
you rescan a removed tape, the backups stored on it reappear in the database and become
available for data recovery.
 If backups were deleted from a tape either manually or through retention rules (p. 444) but you
want them to become accessible for data recovery. Before rescanning such a tape, eject (p. 208)
it, remove (p. 211) the information about it from the database, and then insert the tape into the
tape device again.
To rescan tapes:
1. If you have no tape-based vault (p. 212) associated with the device you loaded the tapes to,
create one.
2. In the Navigation tree, click Tape management. If connected to the management server, select
the storage node to which your tape device is attached.
3. Perform the fast inventorying (p. 210).
Note During the inventorying, do not select the Move newly detected tapes from the 'Unrecognized
tapes' or 'Imported tapes' pools to the 'Free tapes' pool check box.
4. Click Rescan.
5. Select the vault where the newly detected archives will be placed.
6. Select the Unrecognized tapes pool. This is the pool to which most of the tapes are sent as a
result of the fast inventorying. Rescanning the pool associated with the selected vault or the
Imported tapes pool is also possible.
7. Select the tapes to be rescanned. To select all the tapes of the pool, select the check box next to
the Tape name column header.
8. If necessary, select the Enable file recovery from disk backups stored on tapes check box.
Details. If the check box is selected, the software will create special supplementary files on a
hard disk of the machine where the tape device is attached. File recovery from disk backups is
possible as long as these supplementary files are intact. Be sure to select the check box if the
tapes contain single-pass backups (p. 444). Otherwise, you will not be able to recover the
application data from these backups.
9. If the tapes contain a password-protected archive, select the corresponding check box, and then
specify the password for the archive in the Password box. If you do not specify a password, or
the password is incorrect, the archive will not be detected. Please keep this in mind in case you
see no archives after the rescanning.
Tip. If the tapes contain several archives protected by various passwords, you need to repeat the
rescanning several times specifying each password in turn.
10. Click Start to start the rescanning.