Installation Instructions

location. We recommend you do not change these installation paths. Click Next.

13. Please review the services being installed and upgraded.

14. Press Install to begin the upgrade. Once the installation is complete, you will be shown a

summary of the installed components. Press Exit.

Note: All required components will be automatically installed in sequence. This may take 5 to 15 minutes

depending on your server. Future upgrades will be quicker.

15. At this point in the upgrade process, all necessary software has been installed, but you must now

configure the network interfaces, ports, and certificates that will be used. This step is mandatory.

When exiting the installer, you will be prompted to run the Acronis Access Configuration Utility.

Click OK to continue.

Using the Configuration Utility

On the Gateway Server tab