Install Instructions

Drive ID – Generic Installation Guide
Page 18/23
Acrelec is a trademark of AKSOR - 3 Rue Louis de Broglie – 77400 St Thibaut des Vignes – France - www.acrelec.com
8.5 STEP3 ATTACH DEVICE
Once the surface is cleaned and tape is applied attach device to the enclosure. Press on both top and
bottom of the back of enclosure for 30 seconds.
8.6 STEP 4 CONNECT CABLING
Once the device is fixed, connect the ethernet cable to RJ45 port on the back of the device. Follow below
cabling diagram to ensure that the device is both powered and connected to the restaurant network.
Connection diagram