User Manual

Y1-03-0138V 18
APPENDIX C - BULB REPLACEMENT PROCEDURE
Two 55W, quartz-halogen bulbs are provided with your RCL-100D. If
they should need replacement, they can be ordered through an ACR
dealer or through ACR Electronics. The part numbers are P/N 6001 for
12V units and P/N 6003 for 24V units.
CAUTION: Failure to follow replacement instructions carefully can
result in damage to bulb and/or light. All part sales are final.
To replace the lamps:
1. Disconnect unit from power source and allow bulbs to cool.
2. Remove two screws holding the front flange and glass in place.
3. To remove the old lamp bulbs, grasp base of the lamp and pull
straight out.
WARNING: Do not touch glass parabolic reflector with fingers or
tools!
4. Install the new lamp bulb using a soft clean cloth to avoid touching
the bulb with your fingers. Insert the lamp bulb pins into socket and
press firmly in place.
CAUTION: If the lamp bulbs or reflectors are accidentally touched,
carefully clean with a soft rag and alcohol (isopropanol) before
continuing.
5. Replace the front flange and glass and install the two retaining
screws. Be sure the neoprene gasket is securely in place.
6. Reconnect the unit to the power source.