Instruction manual

PROFICIENCY IN SURVIVAL CRAFT AND RESCUE BOATS OTHER THAN
FAST RESCUE BOATS
9 7
9.7 Starting procedure
1. Lower engine to running position and check the following
• Fuel level
• Oil level (if separate lube oil tank)
• Engine mount secure
• Propeller clear
2. Loosen air-vent screw on fuel tank cap by 2 or 3 turns (if fitted)
3. Firmly connect fuel hose to both fuel tank and engine
4. Squeeze primer bulb until it becomes firm
5. Make sure engine is in neutral, and throttle grip on handle in START
position
6. Clip lock plate onto emergency-stop switch and tie lanyard to your wrist
7. Pull out choke if starting cold engine
8. Start motor by pulling starter handle (manual) or pushing starter switch
(electric)
9. Push choke back in
10. Check for “tell tale” water stream and allow engine to warm up before
moving off.
Fig. 9.8 Starting a Yamaha outboard motor