Radio Call Sign Product Support Manual

Y1-03-0250 Rev. B 17

3. Category I bracket

The SeaShelter

™ Category I bracket has five pre-drilled screw holes to use

for securing the bracket to a flat surface. Remove the SeaShelter

™ lid by

turning the spring loaded knob on the lid 1/4 turn counterclockwise and pull.

The lid will lift away from the top of the base and disengage at the bottom of

the base. The lid is tethered to the base to help prevent loss. Pull the

beacon with steady pressure from the bracket. It is not necessary to remove

the HydroFix™ Hydrostatic Release Unit (HRU) to mount the bracket using

four of the holes. For extreme conditions a fifth hole is available when the

HydroFix is removed and the ejector spring is deployed. The bracket can be

held in place to mark the placement of the screw holes or you can use the

mounting template provided. The use of #10 pan head stainless steel

fasteners (minimum of ½” long) and ½” washers (not included) is

recommended. Make sure that fasteners will not contact any wires or

plumbing before drilling pilot holes.