Product specifications

6. Testing Your Beacon
Your beacon has the ability to perform 2 different tests to
ensure the beacon is working perfectly. The first is a basic self
test which checks the beacons Data Integrity and Memory; 406
MHz Synthesizer; RF Power/Battery; GPS header and sends a
satellite burst. The second test is a GPS Self Test that actuall
y
ACR strongly recommends performing the Self-Test
once per month, or at least two weeks prior to a trip
allowing enough time for service should your beacon
require it.
y
turns the GPS Receiver on, downloads your position and then
transmits this data in the Self Test satellite burst.
Note: Self test should only be performed in the first 5 minutes of
any hour.
Battery Witness Seal Life
If your beacon flashes an initial Amber light at the
beginning of the Self- test, this indicates that your
electronic witness has been broken and you have used
more than 1 hour of battery life. While the beacon will still
operate normally in a distress situation ACR strongly
Basic Self Test (No GPS Data)
During a Self-test your beacon will send a 406 MHz signal coded
as Self-test to the satellite system and a 121.5 MHz homing
signal.
Thi b h h b tt lif t f
60
lf
Light Scheme Light Meaning
operate
normally
in
a
distress
situation
,
ACR
strongly
recommends you have your battery replaced and the
electronic witness reset to ensure that you will have at
least 24 hours of battery power.
Thi
s
b
eacon
h
as enoug
h
excess
b
a
tt
ery
lif
e
t
o per
f
orm
60
se
lf
tests over the 5 year life of the battery.
To perform a Basic Self Test:
1. Unclip the antenna latch from the case.
2. Move the antenna into the upright position
Self Test Passed
Self Test Passed
(Battery: <24 Hours)
3. Depress the Test button for 1 full second
A Green Light will flash followed by a Second Long Green Light
flash and the strobe light. This indicates a successful Basic Self
Test.
Self
T
est Fail
Self Test Fail
(Battery: <24 Hours)
B
Fil
If a red LED flashes at the completion of the Self-test, your
beacon has failed. Repeat the Self-test. If the failure persists,
contact ACR Electronics
or an authorized Battery Replacement
Center for servicing of your beacon.
B
attery
F
a
il
12