Specifications

Y1-03-0244A 25

The fourth test checks for 406 MHz signal strength/RF power. If power is not adequate the

system fails.

The fifth test checks GPS engine readiness. If the GPS is ready the beacon passes.

The fifth test checks GPS engine readiness. If the GPS is not ready the beacon fails.

If all six tests pass, the system advises you that Self-Test passed.

If one of the six tests fails, the system advises you that Self-Test has failed.

This message appears if Self-Test failed. The system advises you to refer to this Product Support

Manual (User Book) for information on what to do and who to contact.

This message appears if Self-Test failed. The system advises you to seek service from an

authorized Service Center. Not only should the beacon be fixed immediately, it also should not be

placed into service until the problem is addressed.

NOTE: “SEEK FIX NOW” has the same meaning as “FIX NOW”

This message appears if Self-Test has passed, but the battery is low. Take the beacon to an

authorized Service Center for a battery replacement.

NOTES regarding Self-Test logic:

1.) When one of the tests fail, the system bypasses the remaining tests

and goes to SELF-TEST FAIL

2.) The only exception to #1 is that if the battery fails, the other tests are

still performed. The system will tell the user if there are other system failures by

flashing SELF-TEST FAIL. If there are no failures other than battery life, the

system flashes SELF-TEST PASS, then BATT LOW.

GPS

TEST 

SELF

TEST

PASS

SELF

TEST

FAIL

SEE

USER

BOOK

SEEK

FIX

NOW

BATT

LOW

GPS

TEST √

406 RF

TEST 