Technical data

Figure 6.

GPS Interface with holster

Figure 7.

GPS Interface without holste

4.7.3 GPS I (Interface) connection

The AquaFix™ 406 GPS P-EPIRB (P/N 2797.2 and 2797.4) comes standard with an Optical GPS

data interface with LED (Hard wire connection to you onboard GPS NEMA 0183 output). Connect

the serial port adapter to your external GPS connection data cable. Connect data plus and minus

leads to your NEMA 0183 output wire (consult onboard GPS manual for proper wiring instructions).

The ONLY reliable way to hook up your marine electronics is to solder the leads together, cover the

solder connection and exposed wire with liquid electrician’s tape, and then slips a section of heat

shrink over the outside and seals it in place.

If the holster is on the P-EPIRB, align the two tabs on

the bottom of the interface with the holes in on the holster directly above the interface port (see figure

6). Push down and turn to secure the interface cable to the holster. If the holster in not on the P-

EPIRB simply hold the interface head on top of the interface port with your finger (see figure 7).

SECTION 5 – P-EPIRB Holster

5.1 The AquaFix™ comes standard with a protective holster that will help protect your P-EPIRB from

damage. To install the holster, deploy the antenna and slide antenna through the open hole located

on the left side of the holster. Slide the holster to the base of the P-EPIRB so that the open antenna

hole is flush with the side of the P-EPIRB. Close the back of the holster around the back of the P-

EPIRB and clip into the front of the holster. Once secured, wrap the antenna around the base of the

holster and clip into antenna slot on the top right side of the holster (See figure 8).

Note: Use extreme caution; do not apply the holster over the antenna. In an emergency it is critical

that you deploy the antenna. If the holster is covering the antenna you will not be able to deploy

properly.

Y1-03-0173 Rev. E 9

5.2 The AquaFix™ holster has been designed to accommodate your extreme adventures. You can

secure your P-EPIRB directly to backpack webbing straps or belts to ensure the P-EPIRB is close at

hand. Ensure the P-EPIRB is secured firmly and is protected before heading out to avoid damage or

loss. ACR recommends that you secure your P-EPIRB someplace that is easily accessible in case of

an emergency for rapid activation.

Note: Use care when attaching items to your P-EPIRB. Clipping attachments, carabineers, rope,

webbing, etc. will all add weigh and can affect the buoyancy of the P-EPIRB. Your P-EPIRB may

not float if items have been attached to it.