User Guide

Installation Manual 33 Y1-03-0212 Rev.B
4.2 Entering the MMSI / IMO / DAC / ESN Numbers
Select from the Main Menu “Service Configuration” Number 6. Menu is SERVICE
password protected with default password “NAUT”. Enter Service Password and use the up
and down arrows on keypad to select “Change MMSI / IMO” than press M5 “Select” or “by
pressing number 3 on the keypad.
Input your MMSI and IMO number and press Save to store data. Unit will reboot itself after
pressing Save. Continue to 4.2 after reboot.
Service Configuration Menu Example:
Note: MMSI and IMO Data input are limited to 9 characters.
N 1^21' E 0^14' |1>0.01|2>1.30|
3
>1.80nm
|----------------------------------
| 6. Service Configuration
-----| |
| +- 1. Change Service Password
View | +- 2. User Password Settings
| +- 3. Change MMSI / IMO
-----| +- 4. Change DAC / ESN
| +- 5. Change AIS Mode
Msg. | +- 6. Restore Factory Settings
|
-----|
|
Displ|
----------------------------------------
NUM| Select->| | |<-Back
N 1^19' E 0^13' |1>0.01|2>1.30|3>1.80nm
|----------------------------------
| Menu
-----| |
| +- 1. Messages
View | +- 2. AIS Status
| +- 3. Voyage Settings
-----| +- 4. Ship Settings
| +- 5. Transponder Configuration
Msg. | +- 6. Service Configuration
| +- 7. Display Settings
-----|
|
Displ|
----------------------------------------
NUM| Select->| | |<-Back