User Guide

7.3 Password Settings
This AIS transponder has two levels of password- 
gives access to user-        
administrative privileges. The default password from the factory is mentioned on your AIS
display at the protection foil.
Once you have entered the system, please change the default password to your own
passwords, for both levels of access. Use different passwords for the different security
levels. Your passwords must meet the following criteria:
Minimum of six (6) characters , maximum of eight (8) characters
Letters must be in UPPER CASE
Acceptable characters are the A-Z alphabet and 0- 9 digits
Password may contain both letters and numbers
After you have changed the password, write it down below.
WARNING: It is very important that the Service password not be lost. Keeping the
password in a second location may be wise. Memorizing the password is best. If you lose
this password, you cannot make any further configuration changes: Access to the AIS is
blocked. Another master key is not available and the unit would have to be returned to the
ACR Service centre. This service is not free of charge.
Ship Service
Password:
(min. 6 - max. 8 chrs.
UPPER CASE, A-Z; 0-
9)
Ship User
Password:
(min. 6 - max. 8 chrs.,
UPPER CASE, A-Z; 0-
9)
Off ship
location of
Service
password:


Y1-03-0211G
97