User Guide

Pos.Pinning:
The screen provides the means to switch the position pinning function of the internal GPS receiver
<On> and <Off>. For vessels operating with SOG < 0,3 knots it is recommended to switch position
pinning Off. Otherwise the internal GPS receiver may deliver wrong position information. The data
input field is fitted with the recommended default value (<on>). Use [Left] & [Right] arrows for
toggling between the two modes of position pinning; the [M5] button is used for saving the settings.
Attention: The system will be restarted after saving the settings.
Dynamic Keys: Sensor Settings
[M5]
[Save]
Save Data Input
[M8]
[Back]
Return to Menu Configuration
Inland AIS Configuration / Blue Sign
This screen allows the user to toggle the quality of the speed, course or heading information
received from an external device. These settings are normally set to low.
NOTE: It is highly recommended to keep the settings on low.
Blue Sign:
Toggle the value from <not available> to <used> when a Blue Sign switch is connected. Setting the
blue sign can be done by an external hardware switch. Please see the Installation Manual on how
to connect the blue sign - cable 2635 (NAU-B502)
BlueSign
Blue Sign
<not available> no blue sign switch is connected
<used> when a blue sign switch is connected
Dynamic Keys: Inland AIS Configuration
[M5]
[Save]
Save Settings
[M8]
[Exit]
Return to Transponder Configuration
N48°12' E 16°26' |1> N/A|2> N/A|3> N/Anm
******* Inland AIS Configuration *******
Quality information
Speed : Low
Course : Low
Heading: Low
BlueSign :<used>
----------------------------------------
| Save | | | Exit
N48^12' E 16^26' |1> N/A|2> N/A|3>
N/Anm
************* GPS Settings
*************
GPS module : <Jupiter>
Pos. Pinning: On
NOTE: The system will restart
when saving these settings.
----------------------------------------
| Save | | | Back
Y1-03-0211G
59