Service manual

LUMISCAN ACR-2000 SERVICE MANUAL - SECTION 3.0 SYSTEM OPERATION
3-1
_________________________________________________________________
3.0 SYSTEM OPERATION
_________________________________________________________________
3.1 Power-Up
The power switch on the LUMISCAN ACR-2000 READER is located in the lower left corner of the
right side panel of the scanner. Two LEDs, one above the other, are located in the lower right corner
of the front panel. The top LED is labeled Power, while the bottom LED is labeled SCAN.
When power is turned on, the Power LED illuminates. Once the power is turned on, the PC power
should also be turned on, booted and the driver installed. The scanner will emit an audible tone when
the driver is installed.
NOTE
The LUMISCAN ACR-2000 READER should be allowed to
warm up for 5 minutes prior to use in order to stabilize the system.
If the scanner is powered off and back on, the host PC driver must be stopped and restarted. This
can be done using the “lsdt” Device in the NT Control Panel.
Figure 3-1 LED Locations