Service manual

LUMISCAN ACR-2000 SERVICE MANUAL - SECTION 2.0 INSTALLATION
2-6
NOTE
If, when the driver loads, no CLUT/CAL files are found or multiple CLUT/CAL files
are found in the root , the driver will default to a 1:1 Correction LUT and no CAL
LUT and it will audibly beep.
The device driver LSDTVxxx.COM (where Vxxx is the version number) must be loaded by the user
for the software to work. To load the driver the user should add the command "lsdtvxxx" to the
AUTOEXEC.BAT or from the MS-DOS command line type "LSDTVxxx". Note that in all
versions of Windows, if you load the driver from a DOS session, it will only work for programs run
from that DOS session, not from programs run from a desktop icon. The driver occupies
approximately 17,500 decimal bytes of memory.
Also, it may be convenient to add “C:\LSDT\Tools” to your PATH statement.
NOTE
Information on driver switches used to alter the DEFAULT driver settings are
described in APPENDIX A: ACR-2000 JUMPER AND SWITCH SETTINGS.
2.3.3 Windows NT Driver Installation
To install the software, place the floppy distribution disk in drive A. Run SETUP.EXE and follow
the instructions. The installation software will create a directory on the hard disk and transfer the
required software from the floppy disk to the hard disk. It will also create an NTLSDT program
group and create or update various registry entries. In the NT Control Panel, a Device will be created
called LSDT. The LSDT Device can be configured to start manually or automatically.
Installation types are:
"Compact" only installs DRIVER, DLL, TOOLS, and LSEXP.EXE
"Typical" same as "Compact"
"Custom" by default installs everything, "Compact" plus development files
(Custom recommended)
NOTE
Read the README.TXT file included on the distribution disk.
The “\SystemRoot” directory below represents the Windows NT main directory. For
example, C:\WINNT (the default), C:\WINDOWS, C:\YOURNAME.