Service manual

LUMISCAN ACR-2000 SERVICE MANUAL - SECTION 2.0 INSTALLATION
2-1
___________________________________________________________________
2.0 LUMISCAN ACR-2000 INSTALLATION
___________________________________________________________________
2.1 Unpacking Instructions
NOTE
INSTALLATION SHOULD NOT BE ATTEMPTED UNLESS THE SERVICE ENGINER HAS
BEEN FACTORY TRAINED
WARNING
THE LUMISCAN ACR-2000 READER WEIGHS OVER 75
POUNDS. IT REQUIRES TWO PEOPLE TO SAFELY LIFT
AND MOVE IT.
THE LUMISCAN ACR-2000 READER USES A LASER FOR
SCANNING. DO NOT LOOK DIRECTLY AT THE LASER
LIGHT.
CAUTION
THERE ARE TWO BRACKETS ON THE BOTTOM OF THE
FRONT ENCLOSURE. THEY MUST NOT BE PLACED ON
THE TABLE BUT POSITIONED SO THEY HANG OVER
THE TABLE TO SUPPORT THE SCREEN EXIT TRAY.
THESE BRACKETS WILL BE DAMAGED IF PLACED ON
THE TABLE.
2.1.1 Tools Required
A 7/16" open end wrench and a large flat blade screw driver are required.
2.1.2 Unpacking the LUMISCAN ACR-2000 READER
Using the large screw driver, remove the clamp brackets from the bottom of the crate.
Lift the crate off the pallet.
Remove the accessories box.
Remove the plastic bag protecting the system.
Using the 7/16" open end wrench, remove the 4 bolts from each corner of the pallet underneath the