Specifications

Chapter 3 – Boat Systems
A.11. Tilt Lock
Lever
The tilt lock lever (Figure 3-12) is used to support the engine in the fully
raised position. The lever is located between the engine housing and the
frame of the engine.
Figure 3-12
Tilt Lock Lever
A.12. Sacrificial
Zinc Anodes
Sacrificial zinc anodes (Figure 3-2, 8 and Figure 3-3, 3, 9) are used to
protect the outboard motor from corrosion. Two of the anodes are located
on the gear case, one on the stern bracket, and two small anodes are located
in the water passages of the engine block.
A.13. Engine
Exhaust Port
The engine exhaust gases are discharged around the propeller shaft
(Figure 3-3, 5) and through the hub of the propeller.
3-14