User Guide

Y1-03-0116 Rev. C

7) Codes 4, 5, 6 are pre-programmed as "OFF" code at the factory and 1, 2, 3 are

preprogrammed as "ON" codes. (See Note 2)

Note 1: Code number 7 is always the universal "OFF" and cannot be reprogrammed

for any other function.

Note 2: The codes on the ACR/L-32RCL Remote Controlled Light are factory

preset, however, other code combinations are able to be set by the user. For further

information, please refer to section number 5 - Customizing the Activation Code.

FIGURE 6

ACR / L-32 RCL / CC-1

REMOTE LIGHT SYSTEM

5.0 CUSTOMIZING THE ACTIVATION CODE

The ACR/L-32RC and ACR/L-32RCL are equipped with 2 code selectors, (See Figure

7) one for "ON", and the other one for "OFF" codes. Each one of the selectors has 6 DIP

switches which are numbered from 1 to 6. Any one of the DIP switches may be positioned

in either "ON" or "OFF" position. At the ACR factory the DIP switches of the "ON" code

selector were set as follows: 1, 2, and 3 to "ON" position (away from case wall) and 4, 5,

and 6 to "OFF" position (toward the case wall). The DIP switches of the "OFF" code

selector were set as follows: 4, 5, and 6 in "ON" position (away from case wall), and 1, 2,

and 3 in "OFF" position (toward the case wall).

With this configuration, code numbers 1, 2, or 3 will turn the ACR/L-32 or ACR/

L-32RCL Light system "ON", and code numbers 4, 5, or 6 will turn the light system

"OFF".