Instruction manual

51
10.2 Option SmartElec2 Controller
0
F
1
10.2.1 Keypad buttons
The buttons have the following functions:
Press the select button to allow navigation.
Press the + button to increase a setting.
Press the - button to decrease a setting.
10.2.2.2 Normal Operation
During normal operation mode the display is
dimmed.
Pressing the button, will put the panel into
active mode. If no button is pressed for several
seconds the display reverts to normal mode.
During normal operation the unit will display for
example:
where ‘0’ is the curtain address,
and ‘25’ the temperature measured
for the unit.
Where multiple air curtains exist in a network,
the display scrolls through each unit in turn,
changing approximately once every second.
0 25
10.2.3 OFF mode.
During normal operation, press and hold the -
button for approximately two seconds. The
display blanks until you release the button. The
heating and fans are now turned off. Releasing
the button in less than this time and the action
has no effect.
Where multiple air curtains exist in a network,
this action turns off all air curtains.
If the air curtain is in operation and under heat
demand, a ‘decimal point’ is shown
after the air curtain address.
0 23 .
10.2.4.1 Activate settings display
To enter the Settings mode press the .
button. This will illuminate the screen. Press
the
. button till the desired setting is shown.
By pressing the button it will also advance
to the next setting.
Note: If a setting has been altered by using the
or or buttons, it must be confirmed by
pressing the button.
10.2.4.2 Settings displays
Press the button to advance through the
settings.
Where multiple air curtains exist in a network
and controlled from a single keypad, these will
be detected and displayed in turn, for example:
Any air curtain in the network can be accessed
by pressing the button when it’s address
appears on the display. The settings can then
be accessed as previously described.
0 28 0 H1
0 F2
0 23
.
0 25
1 22
2 24
10.2.2.1 Normal mode displays
Display Meaning
First power up
No air curtains found
Curtain address and
temperature set point
- --
E rr
0 25
fig.13. SmartElec2 Programmer
10.2.2 Keypad display
10.2.4 Settings Mode