Instruction manual

45
9.2.1 Rotor and motor replacement SE
Step 1
Using a 4mm Allen key slacken the M6 Allen
screws at the side of the grille. Access to the
inside of the air curtain grille can be made. Open
the grille. The grille is hinged to prevent the inner
frame from dropping.
Step 2
Remove fastenings securing the motor end of the
deflector plate, including the single side screw
(arrowed).
Step 3
Remove the four screws securing the rotor
support bracket and the opposite end of the
deflector plate. Remove plate.
Step 4
Using a 2.5mm Allen key, slacken the rotor hub
grub screw.
Note: when refitting ensure that the grub screw
bears on the flat of the motor shaft.
Step 5
Push the rotor support bracket away from the rotor
to release the rotor bearing.
Step 6
Lift the rotor clear of the motor shaft then remove it
from the air curtain.
Step 7
Disconnect fan motor cables including the earth
which is bolted to the chassis. (See below).
Step 8
Remove the four 10mm bolts securing the motor to
its bracket.
SmartElec
Standard controller