User Guide

Y1-03-0164 Rev. A

3.0 BEFORE YOU RUN SETUP

Before you run the FPR-100/10 software, please make sure that your computer

meets the minimum requirements in section 3.2.

3.1 FPR-10 Components

See Figure 5 for a visual representation of each component listed below.

• FPR-10 Interface Unit (Module Assembly) A3-06-2260

• Programming Head, PLB A3-06-2117

• Programming Head, RLB-32/33 A3-06-2119

• Serial Cable Assembly A3-06-2129

• 6 Conductor Cable with RJ11 plug (phone) A2-07-0137

• 240 VAC / 12v DC, 800 mA Euro Compatible A3-03-0263

Power supply

3.2 Check the Hardware and System Requirements

To run the FPR-10, you must have certain hardware and software installed on your

computer. The requirements include:

• Microsoft Windows 95 / 98 /, NT4.0, 2000 or ME.

• Pentium 75 MHz microprocessor (minimum).

• A hard disk with at least 10 megabytes of available storage.

• VGA or higher-resolution screen supported by Microsoft Windows.

• 16 megabytes of RAM.

• A mouse or other pointing device.

• 1 available serial port.

• Printer (optional)

4.0 INSTALLING THE FPR-100/10 SOFTWARE

The FPR-100/10 software may be downloaded from the web at

http://www.acrelectronics.com/download.html. The software is installed using the

setup program included on disk 1. The setup program will install all of the needed

files to your hard disk automatically. The software must be installed in the

C:\FPR100 directory to work correctly. This directory is the default directory in

the setup program.

1. Place the disk marked 1 of 4 into the floppy drive of your computer.

2. Click the START button on the bottom of your Windows operating system.

3. Type a:\setup.exe and press ENTER.