User Guide

Y1-03-0090-2 Rev. D
5
3.0 INSTALLATION
Inspect the repulpable tape (A2-05-0119) holding the antenna and tether to the
body of the unit to make sure they are held securely. Replace the tape if necessary.
NOTE: Before installing or re-installing an ELT, it should be tested and
inspected using the procedure described in section 5 and 6 of this manual.
3.1 Raft Pack Installation
To pack the ELT with a life raft, bend the flexible antenna downward so that it
lays flat against the body of the unit and secure it in place by using the water
soluble tape as shown in Figure 5. The unit is then ready to be packed.
3.2 Mounting Bracket Installation
The ELT-202 may be installed into existing ELT brackets or into an optional ACR
mounting bracket (ACR part no. A3-06-1698). To install the ELT into the
mounting bracket, bend the antenna downward so that it lays flat against the body
of the unit (see Figure 5). While holding the antenna in this position and the unit
upright, insert the unit into the mounting bracket clamps. Secure the ELT to the
mounting bracket by pressing down on the clamps latches.
4.0 OPERATION
4.1 Deployment at sea
To operate the ELT in water:
1) Remove the unit from raft pack or bracket.
2) Tie free end of lanyard to life raft or person.
3) Release unit into the water.
4) Red light at top of unit will flash, indicating proper operation. Within a few
minutes, the repulpable tape will loosen and allow the antenna extend fully
upright.
5) To cease operation of the ELT, remove water from the battery and dry off the
bottom cover with cloth or paper.
4.2 Deployment on land
To operate the ELT on land:
1) Remove the unit from raft pack or bracket and allow the antenna to extend
fully upright by removing tape.
2) Remove the repulpable tape surrounding the lanyard.
3) Grasp free end of lanyard and unravel to release plastic bag.
4) Place lower half of unit in plastic bag.
5) Fill plastic bag with water. *
6) Red light at top of unit will flash indicating proper operation.